What problems should be paid attention to when using the quality grasped by the carton gluing machine? Jinweida will answer for you and hope it will be helpful to you:

 

       1. When the glue is glued, the brush should be even, not too thick, 0.2-0.5 is appropriate, and the tongue edge should be left 2mm without glue to avoid the glue extruded by the glue stick from sticking to the inner wall of the carton. , Sticky boxes should be checked at any time.

 

　　2. When the carton gluing machine is gluing, apply force to roll the bonding part to make the glue organically combine, and wipe the visible glue with a towel or cotton yarn, and the width of the combined groove is guaranteed to be 6-7mm.

 

      3. If the slot width is too large or too small in the pasting box, it should be removed in time. The main reason is that the deviation of the imprint line of the printing mold is too large. The solution: manual shaping is used. , Cause the cardboard to be folded longitudinally or the box body is deformed, the indentation line should be slightly reshaped.

 

　　4. It is not allowed to scratch or scratch the cardboard in the paste box, and no glue sticking on the inner wall of the box is allowed. The quality inspector of the section shall check and verify at any time.

 

　　5. The boxes after bonding can only be packaged after 40-50 minutes to ensure effective bonding.

 

　　6. ​​After the pasting work is completed, the waste paper boxes should be cleaned up in time and submitted to the quality inspector to enter the waste warehouse for certification, and the qualified products should be marked.

 

　　 carton gluer is the main product of our factory, which is directly supplied by the manufacturer at wholesale prices, and more orders are more favorable. The carton packaging machinery, die-cutting machine, box-gluing machine, and paper-mounting machine produced by our factory sell well all over the country.