Most of the failures of the die-cutting machine during work and production are caused by the following four factors. The following is an explanation for everyone.

 

　　 1. What I want to talk about is the layout pressure. If this adjustment is not good, the cutting edge is not smooth, fluffing, and the line bursts during die cutting. The pressure adjustment of the layout should be gradually increased from small to large. It should be small rather than large. The pressure on each layout should be consistent. If you want to get the ideal pressure, you should press out the sample to check, and then continue to adjust.

 

　　Second, the die cutter is also an important factor. The faults caused by it include low die-cutting accuracy, non-smooth cutting edge and fluffing during die-cutting. Die-cutting knives must choose high-quality products with appropriate models and specifications to avoid various situations in the future use.

 

　　 Third, the adhesive strips will cause die-cutting loose boards and paste boards, which will affect the speed and quality. There are also skills in the selection of rubber strips. Choose low hardness on both sides of the embedding line, and the rubber strip is 2 mm higher than the blade; for narrow areas, use high hardness, which should be 0.5 mm higher than the blade.

 

　　 Fourth, indentation line, in order to avoid the occurrence of irregular indentation line powder failure, it is necessary to use high-quality indentation line. The hardness is moderate, the stability is strong, and the thread ends are smooth, and then the appropriate height, thickness, and specifications must be selected.

 

　　 The above four factors are closely related to the quality of the die-cutting machine in production and must be paid attention to. Hope to bring you help, welcome to continue to visit our website.